• 1

Fluid mechanics

Many of our technical equipment and machines use the advantages associated with gas or liquid flows: for mass or energy transport, for power transmission or the utilisation of flow forces to overcome gravity. Often we are not even aware, where flow processes occur.

Only when they get out of control, that is, when they leave the normally accepted level, do they enter our consciousness. Then, however, mostly effective and with sometimes serious consequences. When in 1999 at the 24h race of Le Mans three Mercedes CLR took off from the track like badly balanced paper planes while they were crossing a bump and whirled through the air, the spectators were breathless. The aerodynamics, which was supposed to push the racing cars to the ground, did exactly the opposite in this situation.

In order that the fluid mechanical processes in our devices and machines do not lead to uncontrollable operating states, it is necessary to understand the behavior of the fluids.

 


Ununderstood flow phenomena can endanger safety.
An unsafe system must be repaired or taken off the market!


 

Flows are very complex and can hardly be detected analytically. The measurement possibilities are also very limited or although very complex. The numerical CFD simulation offers the only alternative to make the flow processes visible and understandable for the calculation engineer. Only in this way can he gain a comprehensive picture and explore the limits of what is feasible.

 

AdSimuTec GmbH offers CFD flow simulations as an engineering service for the following areas:

With our work and our expert knowledge we can make a significant contribution to the success of your product ideas and to increasing your competitiveness.

 


Take advantage of our experience so that your products always meet the aerodynamic
requirements and are among the most economical on the market.


 

AdSimuTec.Logo.slogan.b.2.1050x70

AdSimuTec GmbH


Warmesberg 24, 9450 Altstätten, Switzerland

+41 79 471 1612

info[at]adsimutec.com

Mo-Fri: 7:30AM–12PM, 1–6PM

We look forward to meeting you

About us


AdSimuTec GmbH is a small, innovative engineering service provider specialized in the field of numerical simulation with FEM & CFD.

You will find us in Eastern Switzerland, more precisely in the Rhine Valley of St. Gallen. We are only a stone's throw away from Vorarlberg (Austria) and Lichtenstein on the one hand and Baden-Württemberg and Bavaria (Germany) on the other.